Busbar for Terminal Blocks

SVB item number: 63801

View Ratings (2)

View Ratings (2) Questions (2)

Matching ground and busbar for terminal blocks. Length: 0.45 m.

Product details

only €24.95

VAT inc., ex-works

24 | in stock

Having issues?
If you are not redirected to PayPal, it could be due to your browser settings. Please check and if necessary deactivate the setting "Hide IP address" in the settings -> Safari -> Hide IP address. Please also check your browser for updates.

Are you already using this item?

Add to my boat now.

To wish list Compare

At a glance!

Copper

by jean-luc P.

okkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkk

Read all product reviews

by Timo J.

Simple and good.

Read all product reviews

Product data

SVB item number 63801
Description Busbar for terminal blocks
Length 450 mm
Material Copper

SVB recommends

Terminal Blocks

from €1.40

VAT inc., ex-works

12 Versions

Product details

Matching ground and busbar for terminal blocks. Length: 0.45 m.

Note

We often are asked how the common busbar (itm. 63801) is mounted on the blue terminal blocks.
This can be quickly explained by looking at the picture of the terminal blocks.

There is a round opening on the top of the terminal. A screw can be seen a little deeper inside.
This side of the terminal block is for connecting a wire.
We also see an oblong hole in which there is also a slightly deeper screw.
This side of the terminal block is intended for the NEG busbar.
- Loosen this screw with a suitable screwdriver (do not unscrew it completely!).
- Slide the loosened screw with the screwdriver to the other side of the oblong hole.
  At the same time, push the clamping mechanism for the NEG busbar out of the housing - and that's it!
- Loosen the screws of all blue terminal blocks until you can slide the clamping mechanism of each terminal over the NEG busbar.
- Re-tighten the screws.
  Important: The clamping mechanism does not grip over the entire width of the NEG busbar. Make sure that the busbar is inserted into the clamping mechanism as far as possible.
  Tip: When all terminals are mounted on the DIN rail, mount the NEG busbar first on the first and last blue terminal blocks, then on the terminal blocks in between.