Customer ratings

Tank seem to be off good quality but the extension pipe are connected to the flenge with an noon good solution. Mine fell off before mounting.

The tank looks quite robust. The openings can be easily introduced. However, material thickness is not the same everywhere. Make sure that the openings are drilled as far away as possible (at least 3 cm) from the visible seam in the material. I have deducted the point because in the sparse installation instructions is not noted on the fluctuating material thickness.

Have not received it yet so can't really say if it is good or bad. Hopefully it will be sorted out by the best svb assistant team )

the 1st through-hull broke when tightened by hand!

Looks pretty weak and I'm curious about the durability. \ R \ nThe addition of a cork seal seems to me quite economical, because I would have expected a resistant rubber seal.

Very fast delivery.

Unfortunately, the tank surfaces are very uneven and even warped.

This makes it difficult to install fittings. The tank won't seal properly with just regular rubber gaskets. Silicone is unsuitable. I used Pantera PU sealant and am waiting to see how it goes.

I wasn't able to use the additional tank cap.

Assessment of the suction tube: In contrast to the excellent tank, the suction tube is rather inconsistent quality. What a perforated cork seal in the tank interior of the waste water tank, I do not understand. The perforated Aufschraubring makes no sense, because you can not screw in the tank ... So another (rubber) seal had her, screwing is of course also with the perforated Aufschraubringmutter. It must then be pushed over the sealing compound between the black tube and white Kunststoffabsauganschluss. This pushes the much too thick applied sealant, what the pipe easily dissolves. Therefore only 2 stars.

Very difficult to connect fittings or hull fittings because the interior has very irregular surfaces. This is a big problem because it causes leaks. Provide a good dose of silicon to remedy this.

It is difficult to place the inlet and outlet fittings, as the wall thickness varies greatly, especially in the center seam area. Tight sealing rings can not compensate for these unevenness, sealing compounds are unsuitable because they do not adhere to the tank material.