Customer ratings

Rubber Seals for Through Hulls

Come on board, follow us and see our hot deals and immense water sports selection for yourself!

Subscribe now!

Excellent

from 203680 Ratings

5,0/5.0 stars

Objednavka dosla vporiadku dakujem

More ratings

Made in Germany

(61)

Rubber Seals for Through Hulls

from €1.95

5 variants

4.6 (out of 61 ratings)

5 Stars

(45)

4 Stars

(11)

3 Stars

(2)

2 Stars

(2)

1 Stars

(1)

by Sven M.

8/4/2020 Verified purchase Variant: 34547

Translate this text

Erfüllt seinen Zweck..

und funktioniert. Der Preis dafür ist etwas überdimensioniert.

by Sven M.

8/4/2020 Verified purchase Variant: 34551

Translate this text

Erfüllt seinen Zweck...

und funktioniert. Der Preis dafür ist etwas überdimensioniert.

by Alain D.

7/29/2019 Verified purchase Variant: 34552

Translated automatically
Show original text

Very good product

Compliant and above all waterproof

by Rodolphe T.

11/22/2018 Verified purchase Variant: 34551

Translate this text

Fonctionne

by Rodolphe T.

11/22/2018 Verified purchase Variant: 34547

Translate this text

Fonctionne

by Norbert P.

1/12/2015 Verified purchase Variant: 34551

Translated automatically
Show original text

Unfortunately necessary price quite steep

by Ralf K.

4/9/2020 Verified purchase Variant: 34551

Translated automatically
Show original text

Much too small

Doesn't fit over the thread, nor does the outer slide reach to the edge of my thru-hull fitting. I found better seal on ebay. These end up in the trash

by Jean louis M.

3/3/2019 Verified purchase Variant: 34548

Translated automatically
Show original text

Noticed

The hull pass gaskets cannot be mounted on a 34 "hull pass because the diameter is 26 mm. They must be taken up with a cookie cutter. Note that the diameter of the pouch containing the joint is 26mm.

by Gernot S.

5/8/2022 Verified purchase Variant: 34548

Translated automatically
Show original text

The product was ok, but did not fit my requirement

The product was ok but didn't fit my needs

by Andre R.

6/16/2015 Verified purchase Variant: 34548

Translated automatically
Show original text

They are a perfect fit, but a little too thin. \ R \ n \ r \ nThey may work in the area of the fuselage openings (although I would rather use Sikaflex here), but I find this type of seal for installation in a plastic waste-holding tank with its bumps thin.

by Günther B.

7/21/2020 Verified purchase Variant: 34549

Translated automatically
Show original text

Purpose of use

The seal is designed for 1 inch threads (25.4 mm). But it has an inner diameter of 32 mm. That can't fit.

Our answer

Das ist für Gewindedurchmesser nicht richtig. Ein 1" Schlauch hat einen Innendurchmesser von ca. 25mm aber ein 1" Gewinde hat einen Aussendurchmesser 33mm. Nicht Schlauchdurchmesser mit Zollgewinde verwechseln.

Back to product Rate this product