Customer ratings

NMEA 2000 MiniPlex-3 with USB works completely as promised in the description. SeaTalk input and output must be activated on a computer using the supplied software, as well as the program is a comprehensive setting possible (eg activation of selected outputs to NMEA 2000). The program language and operating instructions are in English.

I am very satisfied with the device. Could connect my Raymarine devices (Autopilot, Logge, Lot, AIS, Remote Control, Radio) via Seatalk1, wonderfully with my new Simrad NSS 7 evo2 plotter. Even the configuration went smoothly, although my English is not very good.

Use the Multiplexer to integrate SeaTalk1 (Autohelm Log, Lot, Wind and 6000) in NMEA2000. Works flawlessly, all data on the plotter and the laptop.

It works perfectly and corresponds to the description

Good product, works flawlessly.

Very good product which does everything it claims. I have Seatalk1NMEA0183 inputs and outputs connected and everything works fine. NMEA2000 is also working as advertised.

Excellent product.

This multiplexer allows everything that is described in the manual. As a non-navigation electronics engineer, it took a while... ;-))..., but in the end everything works as it should. Full control over the data flow on board. In our case between NKE (NMEA0183), NMEA2000, on-board PS and VHF. Overall, highly recommended!

We had a previous model and it was very reliable. I think it's a shame when a product is sold on the German market and there are no German instructions included.

Software installation a little cumbersome. Put together instruments Seatalk, nmea0183 and nmea2000 operated at the first shot without the need for special configurations

Intended Use Coupling of B & G Plotter (NMEA2000), FM Radio (NMEA-In), EasyAIS (NMEA-Out), SpeedEchoWindAutopilotCompass (SeaTalk1 InOut), Notebook (USB InOut) 1st attempt (firmware 1.13) All data on the Config- Tool of the MiniPlex and on the USB-PC interface, SeaTalk data on the plotter, GPS data on the FM! AIS does not arrive at the plotter, routing data from the plotter is not on the Raymarine ST4000 autopilot 2nd attempt (firmware 1.17) AIS issue fixed. After some reaction time to a demand came the news from England, problem of the plotter data in the direction of SeaTalk1 announced, it follows shortly the update 2.0, then the part would then be 100% worth its money. Good processing, easy connection, good config tool, the data flow can be filtered, so that eg the spark is not "bothered" with wind information. If the German support had also answered times, I would give 5 stars. So guys, WAKE UP!

Has not yet been installed. Looks well made. \ R \ nFunctionality can only be answered in spring.