Customer ratings

Everything was great, gladly again!

Has passed the test run, long-term experience nco none

Unfortunately, it's not installed yet.

The delivery time was a bit long.

After a somewhat difficult installation, it works perfectly.
Unfortunately, the cable entry is very small and the terminal block is positioned too low.
This causes cables to bend sharply and prevent the cover from snapping into place.

General installation is easy - put the sensor in a dry place where gas will flow over it if there's a leak, run the wiring to where you want to install it, connect the sensor and power, and it's done. A quick "leak" of a lighter over it, and it alarms nearly instantly.

However, the actual construction of the device is poor, and very tricky to get apart and back together. Lots of bending of plastic pieces is required. I could probably 3D print a better casing with a better ledge design to hold the circuit board, and a bit more room to bend the cabling on to the terminals.

The gas detector works perfectly. The workmanship is of rather inferior quality, the plastic is thin and brittle.

Device works. It should be clear, however, that you first have to take the detector apart and then complete the wiring. This process is not described for the power supply max 1mm2, but is not in the description.

Who guarantees functionality if I have to remove the circuit board from the device myself to install it and connect the sensors? That's a really poor design and absolutely not recommended.