COLOMBO LED Light, plastic

View Ratings (27)

View Ratings (27) Questions (0)

LED light with white and red LEDs. The LEDs can be switched separately. Housing: plastic, white.

Product details

This product is no longer available.

More alternatives: Ceiling Lights

Good workmanship, fast installation, pleasant bright white light, both light intensities red and white. good.

Read all product reviews

by Raffaele D.

Good but the courier was very slow

Read all product reviews

by Boldea A.

What I need For the actual price evrithing is ok! SVB the best!

Read all product reviews

Accessories

Cable Clamps

from €6.50

VAT inc., ex-works

4 Versions

Rubber Cable Bushings / Industry / 1 pc

from €3.95

VAT inc., ex-works

5 Versions

Flexible Control Cable, Dual Core

from €2.95

VAT inc., ex-works

2 Versions

Shrink Tubing / red / sold per metre

from €2.95

VAT inc., ex-works

3 Versions

Shrink Tubing / black / sold per metre

from €7.50

VAT inc., ex-works

2 Versions

Adhesive Cable Tie Mounts

only €4.95

VAT inc., ex-works

Splice Connector / pack of 20

from €3.40

VAT inc., ex-works

2 Versions

Installation Conduit

from €1.00

VAT inc., ex-works

4 Versions

Product details

The LED light COLOMBO is equipped with white and red LEDs. It has an extremely low power consumption. Switch: on / off / on – you can switch the white and red LEDs separately. Bulbs included.

Operating voltage:	12V DC
Light:	LED (fixed)
Wattage:	2 watts (white) / 1 watt (red)
Power consumption:	0.17A @ 12V (white) or 0.08A @ 12V (red)
Housing material:	Plastic (white)
Outside Ø ::	approx. 140mm
Height:	28mm

Installation instructions

To install the light, the "lens" must first be removed. You will need a small, slotted screwdriver to do this. The lens is attached to the light housing via a snap-in lock. Take care when handling! There are 3 small slots on the edge of the lens, each 120° apart from the other. To open, carefully insert the small screwdriver into one of the slots, raise the "glass" slightly and then remove it completely.

Replace the lens in reverse order. Make sure that the 3 snap hooks are positioned above the 3 locking catches on the housing and push the "glass" onto the base until it is locked again in all 3 positions.