ISOTHERM SQUARE 16 Water Heater / stainless steel / rectangular / 16 litre

As far as can be seen, the product is processed quite properly. However, a compression fitting on the factory-fitted thermostatic valve was leaky and could not be tightened even by tightening it. I had to remove the valve and seal it with sealing tape. The previous boiler was connected with 16 mm cooling water hoses. SVB also has such hoses in its range, but unfortunately no suitable fittings for them. I then had to get it from a specialist retailer the third time I tried. My Beneteau with Volvo Penta 2010 is certainly not exotic. Since SVB itself even offers 16 mm hoses, suitable fittings should also be in the program. Another note on assembly The boiler is quite heavy. When mounting on a wall, make sure you have a mounting support, otherwise you will quickly bend the stainless steel retaining straps. Once bent open, you can no longer pull it so tight that the clamping screw grips again at the top. If necessary, take 6 mm threaded rods with you. This gives you more leeway to pull everything back together if something has been bent. The boiler is working properly. A clean and space-saving solution mounted on the bulkhead.

Sending poorly protected no polystyrene, the plastics are broken, for 600 euros it is a little light ... The heater works, n having no time to make a complaint I can not assess the customer service svb ... disappointed for the first time by svb.