TOPLAC High Gloss One-Component Varnish

Application instructions:

For coated surfaces
In good condition: Wash down with a suitable detergent, rinse with fresh water and allow to dry. Abrade with 280­320 grade (grit) paper.
In poor condition: Remove all previous coatings and prime the surface.

All surfaces: Apply a primer and allow to dry. Abrade with 320-400 grade (grit) paper. Then apply 1-3 coats of Toplac.

Bare wood: Abrade with 80-180 grit sandpaper. Then with 280 grit paper. Remove sanding dust by brushing, dusting and wiping. Allow to dry completely before applying primer.

Aluminium: : Degrease with solvent or Super Cleaner. Sand well using 60­120 grade (aluminium compatible) paper. Clean thoroughly and allow to dry. Prime with One UP as soon as possible (within 8 hours).

Steel: Degrease with solvent or Super Cleaner. Gritblast to Sa 2½ ­ near white metal surface. If gritblasting is not possible, grind the metal surface with 24­36 grit abrasive discs to a uniform, clean, bright well roughened metal surface (50­75­microns) anchor pattern. Use angle grinder on small areas. Clean thoroughly and allow to dry.

GRP: Degrease with solvent or Super Cleaner. Sand well using 180­220 grade paper. Clean thoroughly and allow to dry. No primer required.

Old / weathered gelcoat: Degrease with thinner or Super Cleaner. Thoroughly sand with 180-220 grit sandpaper. Clean well and allow to dry. To prevent blistering, apply 3 coats of Interprotect. When using Interprotect, a primer must also be painted before using Toplac.

Drying time at 15 °C: 3 hours
Processing time at 15 °C: min. 16 hours
Processing temperature: +5 °C to max. 35 °C