YACHT DEVICES NMEA2000 Outboard Gateway YDOG-0 / Micro-C
SVB item number: 90329
Manufacturer no.: YDOG-01N
This gateway is specifically designed for outboard motors without digital interfaces and provides NMEA 2000 devices with engine speed, alternator voltage and operating hours. Product details
Having issues?
If you are not redirected to PayPal, it could be due to your browser settings. Please check and if necessary deactivate the setting "Hide IP address" in the settings -> Safari -> Hide IP address. Please also check your browser for updates.
If you are not redirected to PayPal, it could be due to your browser settings. Please check and if necessary deactivate the setting "Hide IP address" in the settings -> Safari -> Hide IP address. Please also check your browser for updates.
Are you already using this item?
Add to my boat now.
Available variants
Product data
- SVB item number 90329
- EAN 4779045210717
- Manufacturer no. YDOG-01N
- Description YACHT DEVICES - NMEA2000 outboard gateway YDOG-0
- Converter type Analogue-digital
- For Motor Outboard
- For 4-stroke outboards Evinrude, Honda, Johnson, Mariner, Mercury, Parsun, Selva, Suzuki, Tohatsu, Yamaha, Force, Nissan
- Digital output NMEA2000
- Digital input No input
- Analogue input Frequency
- Analogue inputs (total) 1
- Analogue resistor inputs No input
- Analogue frequency inputs 1
- Data transfer Operating hours, Rotational speed, Charging voltage
- Accessories for Chartplotters, Petrol outboard motor
Product details
Designed specifically for outboards without digital interfaces, this gateway provides NMEA 2000 devices with engine speed (RPM), alternator voltage (measured at the NMEA 2000 interface) and engine hours. It can also be programmed to use data from NMEA 2000 temperature or pressure sensors and send these data as coolant and oil pressure or temperature, boost or fuel pressure. You can also programme the device to issue high revolutions, high temperature and low voltage warnings, and set the state of the charge indicator (displayed on MFD or NMEA 2000 display).
If your boat has a single battery, the low voltage alert can keep things from getting to the point where your engine's voltage regulator or alternator gives out when the battery is almost dead. In the settings, you can connect external NMEA 2000 thermometers and pressure sensors to the gateway, configure and set threshold values for alarms and warnings (high engine speed, high temperature, low voltage). The firmware can be updated using the free CAN Log Viewer software (works under Microsoft Windows, Linux and MacOS X). To configure other settings, you will need a PC gateway and software.
CONNECTION:
All that is required to connect the Gateway is to connect it to the NMEA 2000 backbone, wrap its wire around the spark plug wire four or five times, and tape the loops in place. Most of the time, there are no extra settings needed, however depending on your engine type and ignition system, you may need to adjust the RPM divider.
If your outboard engine is big enough, the device can be placed inside the engine. Ensure that it is firmly attached, well-ventilated, kept away from heat sources, and shielded from any potential sprays of petrol, oil, or water. You can install the Outboard Gateway and NMEA 2000 Wi-Fi Gateway inside the motor and power them from the ignition if you're having trouble routing the NMEA 2000 cable to the motor. A concealed button on the Gateway allows you to reset the device's settings, change the engine number (0–3), and adjust the RPM divider (0.5–8). To install the device, just these settings are required. The 4-stroke and 2-stroke engine types as well as the kind of ignition system you have will determine the value of the RPM divider (1 is the factory setting). Most modern 2-stroke engines need a divider of 0.5 (multiply on 2) for counted pulses, and most 4-stroke engines need a divider of 1 (the number of sparks is equal to the number of revolutions).
To check the signal, the device has an LED that emits a sequence of four two-colour flashes every five seconds. The colour of the first flash of a sequence indicates whether the device has a signal at all (with at least 50 % amplitude); and the colour of the second flash indicates whether the signal is of good quality (over 60 %). The Outboard Gateway is supplied with an NMEA 2000 micro connector. An adapter cable may be required for other networks.
Technical data
If your boat has a single battery, the low voltage alert can keep things from getting to the point where your engine's voltage regulator or alternator gives out when the battery is almost dead. In the settings, you can connect external NMEA 2000 thermometers and pressure sensors to the gateway, configure and set threshold values for alarms and warnings (high engine speed, high temperature, low voltage). The firmware can be updated using the free CAN Log Viewer software (works under Microsoft Windows, Linux and MacOS X). To configure other settings, you will need a PC gateway and software.
CONNECTION:
All that is required to connect the Gateway is to connect it to the NMEA 2000 backbone, wrap its wire around the spark plug wire four or five times, and tape the loops in place. Most of the time, there are no extra settings needed, however depending on your engine type and ignition system, you may need to adjust the RPM divider.
If your outboard engine is big enough, the device can be placed inside the engine. Ensure that it is firmly attached, well-ventilated, kept away from heat sources, and shielded from any potential sprays of petrol, oil, or water. You can install the Outboard Gateway and NMEA 2000 Wi-Fi Gateway inside the motor and power them from the ignition if you're having trouble routing the NMEA 2000 cable to the motor. A concealed button on the Gateway allows you to reset the device's settings, change the engine number (0–3), and adjust the RPM divider (0.5–8). To install the device, just these settings are required. The 4-stroke and 2-stroke engine types as well as the kind of ignition system you have will determine the value of the RPM divider (1 is the factory setting). Most modern 2-stroke engines need a divider of 0.5 (multiply on 2) for counted pulses, and most 4-stroke engines need a divider of 1 (the number of sparks is equal to the number of revolutions).
To check the signal, the device has an LED that emits a sequence of four two-colour flashes every five seconds. The colour of the first flash of a sequence indicates whether the device has a signal at all (with at least 50 % amplitude); and the colour of the second flash indicates whether the signal is of good quality (over 60 %). The Outboard Gateway is supplied with an NMEA 2000 micro connector. An adapter cable may be required for other networks.
Technical data
| Supply voltage | 9-16 volt |
| Power consumption (amps) | 30 mA |
| RPM range | 200-70000 rpm |
| Speed accuracy | +/- 0.5 % |
| Voltage measurement accuracy | +/- 0.05 volts |
| Engine hours measurement | 1 second |
| Operating temperature range | -20 to +80 °C |
| Device case length (without connector) | 40 mm |
| Cable length | 2000 mm |
| Wire temperature range | -50 to +180 |
| Weight | 25 g |
Product safety
Customers ask customers
No questions asked yet. Be the first to ask a question!
Comparison
Availability / Price
Item no.
90329
90330
Customer ratings
Description
YACHT DEVICES - NMEA2000 outboard gateway YDOG-0
YACHT DEVICES - SeaTalkNG outboard gateway
For Motor
Outboard
Outboard
For 4-stroke outboards
Evinrude, Honda, Johnson, Mariner, Mercury, Parsun, Selva, Suzuki, Tohatsu, Yamaha, Force, Nissan
Evinrude, Honda, Johnson, Mariner, Mercury, Parsun, Selva, Suzuki, Tohatsu, Yamaha, Force, Nissan
Data transfer
Operating hours, Rotational speed, Charging voltage
Operating hours, Rotational speed, Charging voltage
Converter type
Analogue-digital
Analogue-digital
Digital input
No input
No input
Digital output
NMEA2000
SeaTalkNG
Analogue inputs (total)
1
1
Analogue input
Frequency
Frequency
Analogue resistor inputs
No input
No input
Analogue frequency inputs
1
1
Accessories for
Chartplotters, Petrol outboard motor
Chartplotters, Petrol outboard motor
Similar items
VERATRON (VDO)
Oil Pressure and Oil Temperature Sensor / NMEA2000
only
€190.95
6
VERATRON (VDO)
Resistance Sensor / NMEA2000 Gateway
only
€119.95
5
VERATRON (VDO)
NMEA2000 Exhaust Sensor
only
€324.50
1
-6%
YACHT DEVICES
NMEA2000 Temperature Sensor for Gases, Ambient Air and Liquids
€213.66
only
€199.95
-6%
YACHT DEVICES
SeaTalkNG Temperature Sensor for Gases, Ambient Air and Liquids
€213.66
only
€199.95
-17%
LXNAV
SmartEMU NMEA2000 Motor Interface
€357.00
only
€294.95
6
VERATRON (VDO)
NMEA2000 Gateway / J1939
only
€143.95
7
-9%
YACHT DEVICES
NMEA2000 Motor Interface / Micro-C / YDEG-04N
€281.49
only
€254.95
39
-9%
YACHT DEVICES
NMEA2000 Engine Gateway YDEG-04R
€281.49
only
€254.95
-8%
YACHT DEVICES
NMEA2000 J1708 Engine Gateway
€326.71
only
€299.95
Expected to be in stock within 1-2 weeks
Last seen products
HONDA
Cotter Pin 90758-ZV1-000
only
€2.20
18
-9%
YACHT DEVICES
NMEA2000 Engine Gateway YDEG-04R
€281.49
only
€254.95
HONDA
Adjusting Rod, Complete 50340-ZW9-010
only
€43.95
Expected to be in stock within 4-6 days
HONDA
Rubber, Thermostat 19302-921-003
only
€9.40
4
HONDA
Oil Filter (Denso) 15400-ZZ3-003
only
€20.50
16
HONDA
Cap, Propeller 58141-ZV1-000
only
€14.95
10
HONDA
Shear Pin 58131-ZV1-010
only
€4.50
45
-10%
MARCO
Automatic Pressure Water Pump UP12/A / 36 l/min / 24 V
€552.16
only
€494.95
Available on 15.06.2026
E-mail Newsletter
Product news, offers & new guide videos. Stay up to date!
WhatsApp
New: Get news from SVB straight to your phone!