Phaesun has made a strong impression with this foldable solar module that includes a charge regulator and plug-in connection adapters. Designed for flexible and mobile use, it impresses with simple connection and high energy yield in the most limited space. An innovative design and low weight of only 5.6 kg, you can take all connection components with you and transport them easily.
When folded in the textile frame, this module is an unobtrusive companion, quickly ready for use anywhere and easy to stow away again afterwards. The textile module support has riveted eyelets (9.5 mm inner diameter) for hanging or fixing the module, such as with rubber cord or ratlines. The module can, of course, be laid out quite simply. It also comes with set-up supports that may be used to align the module to low sun and are secured in place by Velcro straps when not in use.
The outside pocket contains all connection cables (1 m module connection, 3.9 m at the input of the VICTRON charge controller and approx. 1.4 m at the controller output), as well as 3 adapter cables for connection to the battery or to the vessel's electrical system.
The adapter cables are each 1m long and fitted with crocodile clips, ring terminals (8 mm ring inner Ø) and cigarette lighter plugs (incl.
10 A fine-wire fuse).
All cables and adapters have solid and reverse polarity protected plug connections, can be rapidly plugged together as needed, and sealed against dirt and corrosion when not in use. When connected, the cable lengths between the module and the charge controller are 4.9 meters, and the cable length between the charge controller and the battery/vehicle power connection is approximately 2.4 meters.
Technical data
| System voltage |
12 V |
| Nominal power |
135 W (3x 45 W) |
| Voltage at max. power (Ump) |
22.6 V |
| Current at max. power (Imp) |
6 A |
| Open circuit voltage (Uoc) |
26 V |
| Short circuit current (Isc) |
6.4 A |
| Cells / Cell efficiency |
3x 12 mono / 23.9 % |
| Operating temperature |
-10 °C to +60 °C |
| Frame |
Textile |
| Module/Battery/Adapte cable |
approx. 4000 mm / 1500 mm / 1000 mm - 14 AWG or, approx. 2.5 mm² |
| Dimensions unfolded |
1525 x 560 x 10 mm |
| Dimensions folded |
440 x 560 x 20 mm |
| Weight: |
5.6 kg |
| Charge controller type / system voltage / max. solar current |
MPPT / 12/24 V / 10 A / VE.direct / Bluetooth |
| Certificates |
CE, RoHS |
Notes
- When using the crocodile clip adapter or the lug adapter, we also recommend installing a 10 A fuse close to the battery (max. 20 cm).
Fuse holders, fuses and crimp cable connectors are available separately.
For the ring terminal adapter, crimp ring terminals with larger ring inner Ø are available separately. All connection and adapter cables are 14 AWG (American Wire Gauge), which corresponds to approx. 2.5 mm².
- Although the VICTRON charge controller used is automatically capable of recognising 12 or 24 volt battery systems, the module can only be used in 12 volt wiring systems due to the 22.6 volt Vmp output voltage.
- If the charge controller is to be permanently installed in the vehicle with battery negative to ground, module negative and consumer negative connections must only be connected to the NEGATIVE terminals of the charge controller and must never be connected to vehicle ground or bridged in any way. Otherwise the deep discharge protection and overcurrent protection of the charge controller would be bypassed.