Is this kit suitable for an airmar ST800 transducer connected to an raymarine ST60+ ?
Hello Adam, Yes it is.
According to AIRMAR, the ST800 Transducer is mounted in a P120 housing and this paddlewheel kit is correct for a P120 housing.
Does this paddle-wheel fit to the transducer of Ray-marine ST30 Round Bi-data, please?
It should fit because there was no difference in terms of transducers used with ST30 rounded or squared.
Thanks Bernd, so it surely fits to any ST30 model, although some say it is from ST40 and above only:-)
Thanks Bernd, so it surely fits to any ST30 model, although some say it is for ST40 and above only:-)
Please see the reply from Bernd.
Thanks, so it surely fits to any ST30 model, although some say it is for ST40 and above only:-)
With 100% certainty, you can't answer YES. If the ST30 system was delivered with the corresponding AIRMAR transducer at that time, it should fit. Since many manufacturers of nstruments use AIRMAR transducers, it is theoretically possible that this ST30 instrument uses a different transducer than the original. Usually a label is fixed at the connection cable of the transducer, on which the exact product designation of AIRMAR is written. This can tell you whether the transducer you are using is the original AIRMAR transducer or not. Translated with www.DeepL.com/Translator (free version)
Thanks a lot, dear Bernd, I'll do my best to check the label on connection cable:-)
Paddle Wheel Kit za Arimar Smart Tri Multisensor 20-633-01 - how to remove old shaft in order to replace wheel?
If you us the new pin to push the old one out a small bit then a pair of pliers to pull it out. It should be free enough to remove.
In addition, instructions from the manufacturer of such Tx´ AIRMAR: https://www.airmar.com/uploads/InstallGuide/17-207-02.pdf
Product news, offers & new guide videos. Stay up to date!
New: Get news from SVB straight to your phone!