SUNBEAMsystem Tough Flush solar modules are a reliable source of energy even under the harshest conditions thanks to the highly efficient SUNPOWER cells (22.5% efficiency). Due to their impressive technical properties, the Tough-Flush modules are often used in the yacht and caravan sector, as well as in private and industrial off-grid systems.
The surface of these modules is extremely durable and resistant to high UV radiation. The material has a better light transmission than conventional materials. When partially shaded, the physical cell arrangement ensures a higher output power than other modules and the surface structure promotes power generation at low light incidence angles. The surface also has non-slip properties.
Timeless design
The modern black design of the SUNBEAM Tough Black series allows the solar panel to be elegantly installed on sailing and motor boats as well as in caravans.
Special features of this module type
The semi-flexible flush modules, which are only 3 mm thin, feature no obstacles or tripping hazards on the module surface because there is no junction box. This is the only type of module that can be mounted almost flush with the surface (flush mount)!
With rear-side module connection via an inconspicuous, 2-core flat black connector cable. The cable can be glued to dark surfaces / mounting surfaces next to the module, almost so that it is barely visible.
Details at a glance
- Semi-flexible
- High level of efficiency
- Durable and UV-resistant
- Small size and high performance
- Improved yield in partially shaded areas
- Yield enhancing, anti-slip surface structure
- Flush mounting (no annoying connection box on the module surface)
Technical specifications
Because the connecting cables of the flush modules run directly out of the back of the module, there are no integrated blocking / bypass diodes on these modules. For modules with a connection box, these are usually integrated in the connection box.
Bypass / blocking diodes
Use bypass / blocking diodes if necessary (in accordance with the installation instructions). The F1200D Schottky diode (12A / 200V) is suitable for 5 - 350 Wp modules and is available from electronics retailers or from us on request.
To install, the module connection cables must be routed to a dry installation area and, together with the diode, mounted on suitable terminal blocks, e.g. item 47023. With powerful modules, "in-line" installation is not advisable, as the diodes can become quite warm when the module is shaded.
Make sure that the diodes have the correct polarity! A ring or point on the diode housing marks the cathode. This must be connected to the PLUS connection of the module.
Important: Incorrect or reverse polarity connected diodes can damage the solar module.
Technical Data
| Type |
T111F |
| Max. power (Pmax) |
110.8 W |
| Open circuit voltage (Uoc) |
21.76 V |
| Short circuit current (Isc) |
6.32 A |
| Nominal voltage (Ump) |
18.56 V |
| Nominal current (Imp) |
5.97 A |
| Weight |
2.0 kg |
| Dimensions (L x W x H) |
1060 x 540 x 3 mm |
Installation instructions
- In the SUNBEAMsystem installation manual provided, you will find all the relevant information on correct module selection, mounting and electrical installation. You will also find a quick guide with lots of relevant information in our download section.
- PLEASE NOTE: Only SIKASIL WS605S, SIKAFLEX 298FC or ZETTEX MS POLYMER 25 is approved for bonding the modules
- Please check the solar modules after receiving the goods or before installing the panels.
- Do not use modules with more than 50 W on a soft surface. SUNBEAM Tough Flush solar modules with greater than 50 watts of power are designed for permanent installation on a solid surface. Mounting can be done by gluing or screwing.
- For mobile or temporary use, modules up to 50 W and a fixed connection box are more suitable.
Construction type
Semi-flexible
Module connection
Rear side
Connector cable
Flat cable (2-core)
Installation type
Deck
Firm substrate