Modernise the electrical system of your BAVARIA sailing yacht with the REFIT Panel designed to replace the factory-installed Panel 301. The original Panel 301, hinged on the left-hand side, was fitted to BAVARIA sailing yachts from 2008 onwards.
Plug-and-Play Solution
The Refit Panel 301 is supplied with a fully pre-assembled wiring loom, already equipped with the required 14-pin and 6-pin connectors. To enable operation with the standard onboard consumers, simply connect the plug connectors to the vessel’s electrical system. In addition, the three cables for the bilge pump (brown), refrigerator (white), and shower pump (red) are connected to the designated circuit breakers F5, F7, and F9.3
3.5" Battery Monitor
Compared with the factory-installed Panel 301, the Refit Panel features a 3.5" touch display, allowing you to read all essential battery and tank data at a glance. Included in the delivey contents is the Tank Interface TIL, which converts the signals from the factory-installed freshwater and wastewater tank sensors so they can be displayed on the battery monitor.
If your BAVARIA is fitted with two black water tanks, an additional Tank Interface TIL#2 is required. This is available separately.
To display battery status and real-time current flow, the Shunt SHE348 is also required. It can be easily connected to the battery monitor.
Thanks to the shunt, you can monitor the onboard electrical system, obtain a clear overview of the state of charge, detect unusual loads, and optimise your battery management system. The shunt is installed near the service batteries, which on many BAVARIA yachts are located beneath the saloon seating.
Thermal Circuit Breakers
The panel is equipped with 20 thermal circuit breakers for the standard onboard consumers. These provide reliable protection against overload and short circuits. Individual breakers can be replaced easily if required.
By using thermal circuit breakers, the previously used push buttons — some of which were unreliable — as well as all relays that caused unnecessary power consumption, are no longer required.
Versatile Equipment
In addition to the thermal circuit breakers and the battery monitor, the Refit Panel features a USB-C/A charging socket, a 12V cigarette lighter socket, and two changeover switches for navigation light circuits.
Operating voltage
12 V
24 V